The advantages of the R.T.M. method

> The moulded articles can be produced with minimum dimensional tolerances;
> The components have an attractive surface aspect on both sides;
> Up to 50% volume ratio of fibers can be evenly distributed throughout the injected resin layer;
> Inserts can be built into the moulded component;
> The moulds cost less than the ones used for other moulding methods, since they operate at low pressure;
> Ample scope for industrialization when mass-productions are required;
> Vast selection of raw materials available on the market;
> Low volatile emissions during the process;
> Products as thin as 1 mm can be supplied;
> Low percentage of machining waste. No porosity or blisters formed during the moulding operations;
> Worker skills do not affect the quality of the workpieces.

Technical Assistance – Optimized products and productions

Our technical department can help you to plan and optimize your products and productions.
Research into planning and manufacturing moulds and fixtures enables us to obtain on-going improvements in both the production system and the global quality of our moulded articles. Direct comparison between equipment and production has allowed us to quickly develop the R.T.M. system and to acquire useful experience when it comes to planning industrial systems for mass production requirements.